Controls for Monterey, Girona, EPX, EVS, RPX and Apollo rangesControls for Monterey, Girona, EPX, EVS, RPX and Apollo ranges
Dimplex programming cassettes provide fully programmable, energy saving control over a group of up to twenty panel heaters, controlling the output based on room occupancy and temperature requirements.

The programmers switch the heater between comfort and setback temperature settings and are programmable for each hour of a seven day period.

A programming cassette installed in one heater acts as the master control. Other heaters connected to the same circuit follow the master time programme. Individual temperature control of each heater is maintained.





Pilot Wire System
A Master Control (Part No RX9911) transmits a control signal using 4th core pilot wire of the mains cable. This 230v live conductor carries a very low current to activate the setback mode on the heater electronic control. To connect heaters, all pilot wires on a circuit must be joined through the ring main, either using an additional live conductor or a suitable 4-core cable. Using hard wired signalling, no receiver is needed, offering a cost effective means of centrol control. The pilot wire system is ideal for new biuild applications.


Pilot Wire System


Mains Borne SignallingMains Borne Signalling
This system uses standard twin and earth wiring to carry a modulated signal.

To ensure signal integrity, the controller will continue to send signals to other heaters until confirmation is received back. To protect against signal leakage from the property, each controller/receiver interface has a four digit identity code programmed by the installer. The MBS system comprises of a master control (part no RX9912) and receiver modules (part no RX9913) fitted to each of the slave heaters. For multi-zone applications there must be one master heater/programmer for each zone. The Mains Borne System is ideal for use in existing buildings.





Dimplex RX9911 Pilot Wire Programmer
Single Zone Pilot Wire Programmer for Monterey, Girona, EPX, EVS, RPX and Apollo ranges




List Price £53.18 (ex.vat)
Order Online for: £47.00 (£56.40 Including VAT )

Dimplex RX9911 Pilot Wire Programmer


Dimplex RX9912 Mains Borne ProgrammerDimplex RX9912 Mains Borne Programmer

Single Zone Mains Borne Signalling Programmer for Monterey, Girona, EPX, EVS, RPX and Apollo ranges. (Use with RX9913 MBS Receivers)




List Price £113.30 (ex.vat)
Order Online for: £101.00 (£121.20 Including VAT )


Dimplex RX9913 Mains Borne Signalling Receiver
Mains Born Receiver for EVX, EVS, RPX, EPX, Apollo and Calidou Ranges




List Price £57.98 (ex.vat)
Order Online for: £49.00 (£58.80 Including VAT )

Dimplex RX9913 Mains Borne Signalling Receiver


6181Y 1.0mm Grey/Brown6181Y 1.0mm Grey/Brown

Single Core Double Insulated PVC Cable

For use with Pilot Wire Systems. Grey outersheath with brown pvc insulated inner core.





Price per (m):£0.25 (£0.30 Including VAT )


Dimplex single zone programming cassettes RX9911 RX9912 RX9913 for pilot wire and mains borne control of panel heaters



This site is best viewed at resolution 1024x768 or above