Redring Hotbox Electric Boiler


Click Image	Hotbox Halogen Technology The Hotbox wall mounted boiler appliance is suitable for installation onto small sealed heating systems. Using British patented Halogen technology, its ultra compact design provides the versatility and flexibility to be easily installed into a wide range of situations. A series pf halogen Infrared Elements heat the water efficiently and cleanly. Located within specially designed copper housings, each element is fitted directly onto the copper heat exchanger. The heat exchanger links 6 or 10 Halogen elements depending on the size of the boiler. As water circulates through the system the high efficiency elements instantly reach operating temperature and induce heat transfer through the copper heat exchanger. Wet radiators up to a combined output of 12,000 BTU's can be supplied by the LP300; 8,000 BTU's for the L318 NOTE: These boilers should not be considered similar to Gas Combi Boilers Scroll down for further information or click here to buy online




Installation... The small size of Hotbox ensures that even in locations where space is at a premium, it can provide a steady flow of hot water for wet radiators. The Hotbox doesn't require any hot soldering and by using push fit pipes and a standard plug, installation is simple. The Hotbox is designed specifically for use in small, pressurised, sealed system installations. The Hotbox Halogen Boiler incorporates all the components required for sealed systems including pressure gauge, pressure relief valve, expansion vessel, circulating pump, manual reset overheat thermostat, manual air vent. There are two controls on the appliance, one adjusts the water flow temperature, and the other is an on/off switch. A 2m electrical flex with integral plug connects the heater to a standard ring main circuit. The L318 is fused at 10a and the LP330 at 13a. A front panel allows safe installation and servicing from within a suitable cupboard but installers must allow adequate space for servicing, operation of the boiler and air circulation. Check here to view specification in pdf format (12kb)




Efficiency...
Due to its simplicity, the Hotbox keeps installation and commissioning costs to a minimum. The Hotbox can be installed directly into the room which requires heating and as there are no odours or fumes there is no requirement for a flue. The maximum power requirement of the Hotbox is 7.7 amps which is less than an average electric kettle. The Halogen elements used in the unit last up to 2000 hours, with the fitted Hotbox programmer allowing 24/7 control. Therefore energy consumption is directly relative to demand. Typical applications include flats, student accommodation, bedsits, care homes, offices, extensions (as a supplement to existing heating), caravans, boats and underfloor heating. Ordering is straight forward. Calculate the size of boiler from the number of radiators to be powered and the total number of BTU's required. Please also check the available dimensions before placing your order. If in doubt, contact our sales office on 01304 215 575



VIEW OUR COMPLETE BOILER RANGE